![]() ![]() You can grab my email via PM if you're willing to share, or if there's a way to link to it for others as well. I had to use something Festool for this Mahany That would be great I'd like to see the PDF. ![]() This gap has never been a problem in practice. The rear clearance is just enough to allow the rear fence mount to slide without contacting the outfeed table. I can assemble this more than one way, hence the orientation arrows below haha. Slick surface and easy to maintain.Īnother FOG member asked about it so here it is. I also used a trick I learned from David Stanton's videos and that was to sand the top to 220 grit and then use paste wax and power buff with a ROS and steel wool. The sides are made from 15mm Baltic Birch and the top is made from awful home center nominal 3/4" birch face ply. It is actually quite simple, however since it mounts on and off a welded tube assembly, I built this one in place on the saw as I wanted to assure the extension was parallel to the saw table. ![]() One of the challenges is how to mount it due to the rear track for the rack and pinion fence. I took inspiration from a few others that I came across on the internet and built mine to store in a small space and simply lift on and off the saw. Here is a quick assembly, compact outfeed table for a DeWalt jobsite saw. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |